CEL-MAR ADA-13040MG Bedienungsanleitung PDF herunterladen (Seite 14)

5.3.1. NETWORK CONFIGURATION

To make a changes of default setting or new configuration of ADA-13040MG, select on left panel Configuration -> Network and then

on right [IP Settings] (Fig.15) and make the selection: Obtain an IP address automatically using DHCP or Use the following IP

address (in this option, enter IP Address of the converter, Subnet Mask, Default Gateway), press [Apply] for save. After the message

Changes have been saved successfully, from left menu select Administrator -> Reboot on right press [Reboot], will be

programmable reset of the converter and new configuration of network setting will be activated.

Fig. 15. The web page for network setting of ADA-13040MG

5.3.2. SERIAL PORT CONFIGURATION

The configuration of serial port of the ADA-13040MG converter includes: port description, setting of port profile (operating mode) and

setting of serial transmission parameters (baud rate, data bits, parity, stop bits).

Select on left panel Configuration -> Serial Ports and then on a page Serial Port Configuration select [Port 1], will open the

configuration details page, includes:

– Port Profile Settings,

– Basic Serial Settings,

– Advanced Serial Settings,

5.3.2.1. SERIAL PORT PROFILE CONFIGURATION (OPERATING MODE)

Select on right panel Serial Port Configuration -> Port Profile Settings and then press Change Profile... will open the page Select

Port Profile for selection of available port profiles (fig. 16).

Configuration of profile used in typical solutions will be presented in next chapters.

The ADA-13040MG operates properly in profiles as follow:

– RealPort

– TCP Sockets

– UDP Sockets

– Serial Bridge

– Industrial Automation (Modbus Gateway)

Configuration of profiles will be presented in next chapters.

ADA-13040MG

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Keine Kommentare

CEL-MAR ADA-13040MG Bedienungsanleitung Seite 14